When I am tasked with modeling old equipment, I like to do a photo scan (photogrammetry) first. This allows me to go back when I’m done with the design and compare important features. If you have ever made a part and then discovered it was off by 1″ when you went to install it, you’ll understand the value of this.
I once designed a bracket for a generator. I used a tape measure to draw the as received part. Normally, when I use a tape measure, I don’t use the end of the tape. I just don’t trust that the end isn’t bent or the slot in the tape that allows the end to move 1/16″ isn’t damaged. I line up one edge with 10″ and then take the measurement subtracting 10″ from what I read on the other end.
Well…I use 10″ now. I used to measure by lining up the first edge with 1″ and this created the problem with the generator bracket because I forgot to subtract the 1″. The bracket was about 20″ tall and I forgot to subtract the 1″ from the measurement. If I had started with 10″, my error would have been obvious when I was drawing the new bracket.
The lesson learned was that initial measurements are sometimes wrong. If you are modifying a design, that initial photo scan can tell you alot.
So…today I scanned a fluid drive. This is an old American Standard Size 315 Gyrol fluid drive. The size “315” refers to the diameter of the oil circuit inside the fluid drive where 315 = 31.5″.
Even though 99.999% of artist don’t know what a fluid drive is or how it works, they may find the old authentically dirty look an interesting addition to an industrial scene. I didn’t do much work after scanning it. So if you want to use it in a large scene, you may want to decimate it a bit.
https://www.cgtrader.com/3d-models/industrial/industrial-machine/size-315-fluid-drive
Simmer3D 